Hi,
I’m trying to create an animation of a 3D print. I’ve gotten the rig down to essentially create the first layer all driven from one slider. So I dropped that into a Cloner. Is there a way to offset the animation, so that each layer could be printed sequentially, and not all at once? I need to have like 40 layers total. I was trying to mess around with iteration/hierarchy nodes, and it just gets super complicated real fast.
I also thought about combining the Splines into 1, and then use Xpresso to change the Segment parameter in the Align to Spline tag. But I wasn’t able to get that working properly.
Thanks.
...