Dear reader,
Ik made some shapes in Illustrator to get a good mesh for my airplane. All the parts were copied into Cinema.
Turned them in the right direction and added these in a loft to connect into a shape.
It didn’t work out… shape is not what I expected.
Did I make the path wrong? Do I give them the same amount of point to get the shape right..?
Do I have to make the same starting-point when I make them in Illustrator?
With splines there is no problem but paths is an other story 
Is it possible to concert a closed path into a spline?
Can you please help me out en tell me what I am doing wrong?
Thanks in advance!
Michiel van der Velden